Loading ...
Sorry, an error occurred while loading the content.
 

Re: [Z_Scale] Question

Expand Messages
  • martin soll
    Thanks to all who responded to my question about insulating rail joiners for DC block wiring using Rokuhan track.   Several good ideas, not sure yet which one
    Message 1 of 64 , Oct 6, 2013
      Thanks to all who responded to my question about insulating rail joiners for DC block wiring using Rokuhan track.
       
      Several good ideas, not sure yet which one I will use when the time comes.
       
      Marty in Estacada, OR

      From: Alan Cox <alan@...>
      To: z_scale@yahoogroups.com
      Sent: Saturday, October 5, 2013 1:52 PM
      Subject: Re: [Z_Scale] Question
       
      On Sat, 5 Oct 2013 13:41:45 -0700 (PDT)
      martin soll <solldesign@...> wrote:

      > Just getting started on my first Z Scale layout (I built a test track, but no layout). I think I have everything I need to get started with Rokuhan track EXCEPT, insulated rail joiners for DC blocks. I looked at the  Rokuhan website, and the only insulated joiner shown insulates both rails for a reversing loop.
      >  
      > QUESTION: What is the best method to break the continuity on just one rail?

      Cut it with a dremel or similar. It&apos;s then often a good idea to put a
      tiny spec of something in the gap. It&apos;s not needed for the wheel guidance
      (for a thin slit anyway) but it avoids getting nasty problems over time
      if the rail moves with heating and cooling and touches again.

      Or just use a double isolating track and feed power always to both sides
      of the one rail.

      Alan
    • martin soll
      Thanks to all who responded to my question about insulating rail joiners for DC block wiring using Rokuhan track.   Several good ideas, not sure yet which one
      Message 64 of 64 , Oct 6, 2013
        Thanks to all who responded to my question about insulating rail joiners for DC block wiring using Rokuhan track.
         
        Several good ideas, not sure yet which one I will use when the time comes.
         
        Marty in Estacada, OR

        From: Alan Cox <alan@...>
        To: z_scale@yahoogroups.com
        Sent: Saturday, October 5, 2013 1:52 PM
        Subject: Re: [Z_Scale] Question
         
        On Sat, 5 Oct 2013 13:41:45 -0700 (PDT)
        martin soll <solldesign@...> wrote:

        > Just getting started on my first Z Scale layout (I built a test track, but no layout). I think I have everything I need to get started with Rokuhan track EXCEPT, insulated rail joiners for DC blocks. I looked at the  Rokuhan website, and the only insulated joiner shown insulates both rails for a reversing loop.
        >  
        > QUESTION: What is the best method to break the continuity on just one rail?

        Cut it with a dremel or similar. It&apos;s then often a good idea to put a
        tiny spec of something in the gap. It&apos;s not needed for the wheel guidance
        (for a thin slit anyway) but it avoids getting nasty problems over time
        if the rail moves with heating and cooling and touches again.

        Or just use a double isolating track and feed power always to both sides
        of the one rail.

        Alan
      Your message has been successfully submitted and would be delivered to recipients shortly.