Loading ...
Sorry, an error occurred while loading the content.

Re: [Z_Scale] Needed - MTL GP9 springs

Expand Messages
  • eric courtney
    MTL sucks with their support for thei products! Eric ________________________________ From: Lindley Ruddick To: z_scale@yahoogroups.com
    Message 1 of 35 , Feb 23, 2013
    View Source
    • 0 Attachment
      MTL sucks with their support for thei products! Eric



      ________________________________
      From: Lindley Ruddick <elruddick@...>
      To: z_scale@yahoogroups.com
      Sent: Friday, February 22, 2013 11:58:09 PM
      Subject: [Z_Scale] Needed - MTL GP9 springs

       
      I have stretched the little springs that go from the printed circuit board to the tabs on the motor beyond use. MTL cannot supply replacements. I do not want to "hard wire" the connection. Any idea where I could obtain a few?




      [Non-text portions of this message have been removed]
    • Lee Barry
      the F7A engine that came with it, it was the 2012 MTL Xmas set ... From: BAZ Subject: [Z_Scale] Re: MTL Xmas set To:
      Message 35 of 35 , Feb 26, 2013
      View Source
      • 0 Attachment
        the F7A engine that came with it, it was the 2012 MTL Xmas set

        --- On Tue, 2/26/13, BAZ <sjbazman49@...> wrote:


        From: BAZ <sjbazman49@...>
        Subject: [Z_Scale] Re: MTL Xmas set
        To: "z_scale@yahoogroups.com" <z_scale@yahoogroups.com>
        Date: Tuesday, February 26, 2013, 7:24 PM

        So, what did not work, after several repair attempts? I am curious about 'wont run'.

        Sent 'from the road'
      Your message has been successfully submitted and would be delivered to recipients shortly.