Loading ...
Sorry, an error occurred while loading the content.

69557Re: Dead RDC-2

Expand Messages
  • Stew
    Feb 7, 2012
      Rob and Mark,

      I have two RDCs so I took a truck off of the one that was still operating to see if there's something different with the drive shaft. I put it back together and it still ran!

      I still couldn't figure out why the other one's truck wouldn't turn with the drive shaft installed. I decided to swap out the trucks between the dead one and the live one, and now both are running again. Go figure, since I don't know why this solved the problem, but I'm not going to take them apart again as long as they are running.

      I couldn't get the truck installed into the frame unless the drive shaft was seated on both ends. Also the wheels on the truck will not turn with the gears in the truck, so removing the drive shaft on one end is not a solution.

      Thanks for the help.

      --- In z_scale@yahoogroups.com, ztrack@... wrote:
      > Stew,
      > Check this. With the truck removed, insert the drive shaft into the slot on
      > the side of the truck. Does the shaft rotate? If so, we can rule out
      > completely a truck issue.
      > I have found positioning the drive shaft into the chassis can be hit or
      > miss. I sort of work it in a bit and then see if it engages.
      > Another tip is try the RDC without the drive shaft to the questionable
      > truck. Does it run? It will run with only one shaft.
      > Rob
      > Ztrack Magazine Ltd.
      > Distributor American Z Line
      > Authorized MTL, Full Throttle, Tenshodo
      > and Rokuhan dealer.
      > www.ztrack.com
      > www.ztrackcenter.com
      > www.ztrackresale.com
      > www.rokuhan-store.com
      > 6142 Northcliff Blvd
      > Dublin OH 43016
      > (614) 764-1703
      > [Non-text portions of this message have been removed]
    • Show all 14 messages in this topic