Loading ...
Sorry, an error occurred while loading the content.

Re: [wuhu_software_group] Re: Getting high readings?

Expand Messages
  • Bob Tyszka
    I am about to replace the wire on the wind sensor and use a conduit because the solar UV is eating up the cable. Since I am going through this process, has any
    Message 1 of 4 , Nov 16, 2008
    • 0 Attachment
      I am about to replace the wire on the wind sensor and use a conduit
      because the solar UV is eating up the cable.
      Since I am going through this process, has any one re-wired the rain
      gauge from LaCrosse? I thought I would do this at the same time.

      Thanks;

      Bob T.

      CW9012 / KCACALIF5

      wuhu_software wrote:
      >
      > Hami,
      >
      > The La Crosse sensors are prone to bogus wind readings caused by the
      > wiring or noise sources like Ham radio.
      >
      > Short of replacing the wiring, make sure that the wires are secured and
      > are not flapping in the wind. If they are loose, apparently static
      > build-up can cause bad readings.
      >
      > Users who have taken the extra step to replace the wire between the
      > remote thermo and the wind sensor have reported that it does indeed
      > solve the problem.
      >
      > See this page for the instructions on how to make this modification:
      >
      > http://www.lavrsen dk/sources/ weather/windmod. htm
      > <http://www.lavrsen.dk/sources/weather/windmod.htm>
      >
    Your message has been successfully submitted and would be delivered to recipients shortly.