Re: Ideas Please - Lost 2317 Anemometer
- Thanks for the reply - no reversed wires as I labeled the rain & wind
with a wire label & the rain gauge is fine (its showing 0's), I'll
have to check the wires for any nicks but I'm always very cautious
when fastening the wires, the only thing I can think of is I got over
zealous with tightening the tie wraps on the mast & pinched a wire
there. I guess I'll need to take the sensor down & open it up to check
continuity between the RJ45 connector & the internals of the wind
Arnold In The Smokies
--- In firstname.lastname@example.org, "wuhu_software"
> Any chance the wind and rain sensors are reversed at the remote thermo
> Also, any wire damage if you tacked down the wind sensor wire?
> --- In email@example.com, "alrjr2001"
> <alrjr2001@> wrote:
> > Hi Folks - Finally got around to mounting my sensors on my greenhouse
> > shed today getting ready to hook up to WUHU & after setting everything
> > up I have dashes where the wind speed should be. The set up was
> > working fine wireless on the bench for the last few weeks & prior to
> > that I tested the sensors/console over the same distance & placement
> > wireless & all was good to go. I hooked up the console outside briefly
> > hardwired & still just dashes (I must admit it wasnt hooked u very
> > long - maybe 4 or 5 minutes). Any thoughts? Its as if the anemometer
> > died & I have readings for outside temp. & 0's showing for the rain
> > Thanks In Advance!
> > Arnold In The Smokies