Loading ...
Sorry, an error occurred while loading the content.

195Re: [wuhu_software_group] Re: WS3600/WS3610

Expand Messages
  • stevech@san.rr.com
    Sep 13, 2005
    • 0 Attachment

      Handshaking configuration in Windows applies only to the serial COM driver. I doubt that HeavyWeather uses that mode but instead manages its own low level API calls to manipulate the I/O bits so the windows configration settings would be N/A.

      ----- Original Message -----

      From: wuhu_software <wuhu_software@...>

      Date: Tuesday, September 13, 2005 8:07 am

      Subject: [wuhu_software_group] Re: WS3600/WS3610

      >
      > Dave,
      >
      > It is my understanding that the 3600 uses the serial handshake
      > lines
      > to communicate with the unit whereas the 2300 uses regular serial
      > communications.
      >
      > I would suspect that the handshake lines are either no enabled or
      > not
      > compatible with the USB serial converter that you are using.
      >
      > You might investigate hardware handshaking in your USB serial
      > converter manual. There might be some configuration required to
      > enable the handshaking.
      >
      > Then again, it may be a matter of timing. I am not sure if the
      > handshake scheme they are using is timing sensitive or not.
      >
      > Which operating system are you using?
      >
      > There is a support page on the lacrosse site. I would not hold my
      > breath on receiving a bug fix though.
      >
      > --- In wuhu_software_group@yahoogroups.com, "David Higgins!
      "
      >
    • Show all 7 messages in this topic