Re: Question about a Mirage B108 2 meter amp
- --- In firstname.lastname@example.org, "Don Clair" <dclair@4...> wrote:
> an old Mirage B108 Amp...where does the hot and ground go?I was in a similar situation a few months ago. Rather than mess with
the connector, I just extended the power lines and the keying line
out separately through an aperture between the old connector and the
fuse on the back panel. The power lines use a few inches of #10 wire
to a little 2-terminal block, and the keying line is a short stretch
of coax to an RCA female jack. IIRC the keying line shares ground with
the power inside.
It's quite easy to figure out if you take off the bottom of the
cabinet. Works fine, and it's nice to have the keying line separated
from the power line and connector.