Loading ...
Sorry, an error occurred while loading the content.

12310Re: [wsjtgroup] WSJT-X decoding and operating best practice

Expand Messages
  • Joe Taylor
    Feb 7, 2014
    • 0 Attachment
      On 2/6/2014 7:30 PM, Bob McCormick wrote:
      > http://www.physics.princeton.edu/pulsar/K1JT/wsjtx-doc/wsjtx-main-toc2.html
      > In section 12 of the current on-line documentation it mentions:
      >>> For operator convenience the decoder goes through its full
      >>> procedure twice: first at the selected Rx frequency, and then
      >>> over the full displayed frequency range....
      > When the first pass is performed - how tight does the decode focus on the
      > frequency?

      This tolerance is currently set at +/- 20 Hz in both JT9 and JT65 modes.

      Note that offsetting your Tx frequency by a much larger amount may still
      be very effective, with an alert operator. Your decoded transmission to
      him may appear in the left window, not the right, but it will be
      highlighted in red and easy to spot.

      -- 73, Joe, K1JT
    • Show all 3 messages in this topic