In WSPR, go to Setup | Advanced and set Rx BFO to 2200 Hz.
-- Joe, K1JT
On 1/3/2014 12:45 PM, Bob Segrest wrote:
> Hello Everyone,
> I have an Anan-10 HPSDR rig that I use mostly for JT65 and JT9. When I am
> not actively operating I tend monitor the 30M band between 10.138 and 10.142
> MHz using WSJT-X.
> As the WSPR segment on 30M is right in the middle of this, I would like to
> also run WSPR-X concurrently. Everything seems to work, but I'm struggling
> a bit with the WSPR-X tuning. The default radio frequency for WSPR-X is
> 10.138.7 MHz. But I want to keep my rig tuned to 10.138 MHz for JT65
> monitoring. It seems that there should be a way to tune WSPR-X to monitor
> 2100-2300 Hz audio instead of the default 1400-1600 Hz.
> Is this possible?
> Bob Segrest, KO2F