Loading ...
Sorry, an error occurred while loading the content.

10766Re: [wsjtgroup] Rig Control Error

Expand Messages
  • Joe Subich, W4TV
    Jul 13, 2013
    • 0 Attachment
      > I am running a K3 with a Signalink USB interface. win 7 pc, 2.4
      > processor, and 4 gb of ram.

      What are you using for the serial connection? Are you using any kind
      of "port splitter" (e.g. VSPE, etc.)?

      73,

      ... Joe, W4TV


      On 7/13/2013 6:54 PM, kc2nyu wrote:
      > I am having the same problem with r3482 that I had with the previous release. When I start the program, the " Enable Cat " box is unchecked, even though it was checked when I shut the program down. So I check it and the program runs fine for a while and then I get " Rig Control error 0, failed to read freq" msg and the program freezes up, until I clear the msg. I clear the msg , program runs for a while and then it all starts again. I mentioned this before and there was a comment about polling interval. I have mine set now for 10 secs.
      >
      > I am running a K3 with a Signalink USB interface. win 7 pc, 2.4 processor, and 4 gb of ram.
      >
      > Is there a fix for this I can do, or is it a program issue ?
      >
      > 73 Paul
      > kc2nyu
      >
      >
      >
      >
      >
      >
      >
      > ------------------------------------
      >
      > To unsubscribe, send an email to:
      > wsjtgroup-unsubscribe@yahoogroups.com
      >
      > WSJTGroup Homepage --> http://www.wsjtgroup.org/
      >
      >
      >
      >
      >
      > Yahoo! Groups Links
      >
      >
      >
      >
    • Show all 7 messages in this topic