Loading ...
Sorry, an error occurred while loading the content.

10239Re: WSJT-X v3251 'Open Rig Failed'

Expand Messages
  • KD7YZ Bob
    May 13, 2013
    I have done some more testing on this dual-use of single CAT Com-Port.

    Rig is K3 fwiw. I am using Dx-Labs "Commander", which reads and sets certain frequencies and parameters of the K3. The designated port is Com14 .

    So I run Virtual Serial Port Emulator, by Eterologic. I assign COM2 (Virtual) to watch Com14 .

    First I run Commander and have it assigned to COM2 (the virtual) .
    Commander operates correctly; reads the frequency of K3, sets "CW" and co forth.

    Close Commander. Verify is is closed by looking through Task Manager.

    Run WSJTx, JT9 . Assign it to look at COM2 .. If this is not possible due to rig-open problem, I edit the "INI" and delete the section of lines dealing with CAT and COM ports.

    WSJTx functions just fine looking thru the virtual port to the K3.

    Run Commander now. Eventually, sooner or in a minute or so, WSJTx locks up while Commander works through it.

    If OTOH I start Commander first, still using the virtual port COM2, and THEN "try" to run WJTx, there is the immediate Error about open rig and so forth. Kill it with TM .

    Commander is still working.

    Now then, I winder if any other program(s) will work using VSPE and the virtual port COM2 which points to the logical port COM14.

    So I run FLDIGI. I set it to look at COM2 and Voilla! she's a workin' along with Commander who's also looking at COM14 (K3) through Virtual Port COM2 . The setup is through the Hamlib tab, K3 & COM2.

    Close FLDigi. Open "K3 Utility". Assign COM2. Works while Commander is also running thru COM2.

    Keep them open and open "Omni-Rig Client". Make changes to "FREQA". Note K3 has changed frequency on VFO-a.

    Leave all three communicating with K3 through COM2 and open WSJTx. Note
    Open Rig Failed, error. See screenshot of it, attached to this, and likely
    viewable in the Files section via the Yahoo Group interface. Otherwise as me and I will email same screenshot.

    Bob KD7YZ
  • Show all 10 messages in this topic