Loading ...
Sorry, an error occurred while loading the content.
 

Teslafy Feb 2014 flicker jpegs

Expand Messages
  • Harvey Norris
    Some vector subtraction amperage 19.1 ma predictions for the noted low 129 volt, 4 inch neon discharge noted this month. Now the car alternator 465 hz resonant
    Message 1 of 5 , Feb 27, 2014
      Some vector subtraction amperage 19.1 ma predictions for the noted low 129 volt, 4 inch neon discharge noted this month. Now the car alternator 465 hz resonant device  termed a 666 machine by its one sixth cycle equal mutual inductance effect on 3 phase producing a rotating time vector of 24 cycles should prove the astounding efficiency when compared to a 60 hz variac driven NST that should enable identical amperage for bulb performance comparisons, where in the 60 hz NST case the bulb's voltage across this smaller 15 mm 4 inch  neon discharge volume in ~ 500 volts. More 4 inch xenon and krypton bulbs have also been ordered for testing in March. By using the vector subtraction method and the 6800 ohm secondary reactance amperage circulation measurements of the secondaries, the voltage across the discharge can be predicted before it is measured, as these are meter top end voltage measurements. That method should compare the amperage across the bulb relative to the amperage of the two sources secondaries allowed to vibrate independently from their 120 degree sources. Supercold Ohio weather has prevented further corroborative measurements made by this prediction. The belt on the wall voltage motor to the alternator must get very stiff in the sub zero cold weather causing a large amperage surge to the motor which is then kicking out the ten amp breaker on the utility strip it is being sourced from. I don't have the finances to heat the garage for that remedy. No measurements have been made for at least a month and the first order of business upon warmup is to verify the neon amperage ratio. I suspect that when the neons are sourced as loads individually from each secondary alone, that they will have a higher voltage across them; and that it is the wiring between the secondaries to produce predominantly opposing rather then 120 degree predominantly constructive voltages in time that is responsible for this dual sourcing of seriesed secondaries igniting  a neon discharge at such a low 128-129 volt level. HDN
       
      Pioneering the Applications of Interphasal Resonances http://tech.groups.yahoo.com/group/teslafy/
    • Michael Riversong Education
      What ever happened to 3-D holography? This is a case where it s really needed. The fields you are generating with this setup are 3-dimensional. Many of them
      Message 2 of 5 , Feb 28, 2014
        What ever happened to 3-D holography?  This is a case where it's really needed.  The fields you are generating with this setup are 3-dimensional.  Many of them are most likely forming into spirals -- you can kind of see that on some of the scope traces in your gallery.

        So we have to supply the required visualizations ourselves for now.  It's also necessary to start sorting out the significance of certain aspects of the field patterns involved.  We are not just dealing with quantities of power here -- we are dealing with a number of subtle qualities.  Think of the wattage you're generating as broken up into categories just like quarks, even with the silly terminology used in that field of study (beauty, charm, up, down, etc.).

        This is new territory all around.  With all the parameters inherent with each field, it's given that we won't be able to fit any of them into the framework we've been using to describe conventional power systems.

        -----Original Message-----
        From: Harvey Norris
        Sent: Feb 27, 2014 7:24 PM
        To: "vortex-l@..."
        Cc: Jlnlabs
        Subject: [usa-tesla] Teslafy Feb 2014 flicker jpegs

         

        Some vector subtraction amperage 19.1 ma predictions for the noted low 129 volt, 4 inch neon discharge noted this month. Now the car alternator 465 hz resonant device  termed a 666 machine by its one sixth cycle equal mutual inductance effect on 3 phase producing a rotating time vector of 24 cycles should prove the astounding efficiency when compared to a 60 hz variac driven NST that should enable identical amperage for bulb performance comparisons, where in the 60 hz NST case the bulb's voltage across this smaller 15 mm 4 inch  neon discharge volume in ~ 500 volts. More 4 inch xenon and krypton bulbs have also been ordered for testing in March. By using the vector subtraction method and the 6800 ohm secondary reactance amperage circulation measurements of the secondaries, the voltage across the discharge can be predicted before it is measured, as these are meter top end voltage measurements. That method should compare the amperage across the bulb relative to the amperage of the two sources secondaries allowed to vibrate independently from their 120 degree sources. Supercold Ohio weather has prevented further corroborative measurements made by this prediction. The belt on the wall voltage motor to the alternator must get very stiff in the sub zero cold weather causing a large amperage surge to the motor which is then kicking out the ten amp breaker on the utility strip it is being sourced from. I don't have the finances to heat the garage for that remedy. No measurements have been made for at least a month and the first order of business upon warmup is to verify the neon amperage ratio. I suspect that when the neons are sourced as loads individually from each secondary alone, that they will have a higher voltage across them; and that it is the wiring between the secondaries to produce predominantly opposing rather then 120 degree predominantly constructive voltages in time that is responsible for this dual sourcing of seriesed secondaries igniting  a neon discharge at such a low 128-129 volt level. HDN
         
        Pioneering the Applications of Interphasal Resonances http://tech.groups.yahoo.com/group/teslafy/

        
        -- Michael Riversong
        Tesla Academy
        Fort Collins, Colorado
        www.teslaacademy.info
        rivedu@...
      • harvich
        It is possible to create a voltage vector that rotates in time so that essentially a heterodyning effect is made where the only machine constructed to show
        Message 3 of 5 , Mar 1, 2014
          It is possible to create a voltage vector that rotates in time so that essentially a heterodyning effect is made where  the only machine constructed to show this effect is known as the 666 machine. Every 24 cycles out of a total of 465 cycles per second this circling "separated" magnetic field reacts with its input where situations are somewhat easily engineering whereby a portion of the normal alternator function as a generator is reversed and instead a portion of the machine begins to work backwards, instead propelling electrical energy back to its source, whereby this additional voltage then registers on the phase being affected.
          http://www.flickr.com/photos/harvich/8291688443/
          A "third" magnetic interaction between adjacent secondaries in the phase rotation occurs whereby the combined secondary emfs on the ending of the phase rotation completely oppose the primaries magnetic field, and thereby its amperage.
          http://www.flickr.com/photos/harvich/12493185733/
          http://www.flickr.com/photos/harvich/12493133615/
          The opposite pulsing of each secondary source combined together as a meter reading
          332 volt seriesed output taken from "cyclic" secondaries at no field input to alternator.
          Taken from the you tube video

          http://www.flickr.com/photos/harvich/12493457914/
          I have a special  dual bus alternator larger machine that allows me to run two three phase processes at any desired phase angle between them.  Thus it should be possible to engineer these AC superimposed pulses to instead occur near ten hertz, which is said to be the resonant frequency of the earth itself.
          HDN
        • McGalliard, Frederick B
          Sorry. And why exactly would the earth resonant frequency play any part in this? From: usa-tesla@yahoogroups.com [mailto:usa-tesla@yahoogroups.com] On Behalf
          Message 4 of 5 , Mar 1, 2014

            Sorry. And why exactly would the earth resonant frequency play any part in this?

             

            From: usa-tesla@yahoogroups.com [mailto:usa-tesla@yahoogroups.com] On Behalf Of harvich@...
            Sent: Saturday, March 01, 2014 11:06 AM
            To: usa-tesla@yahoogroups.com
            Subject: Re: [usa-tesla] Teslafy Feb 2014 flicker jpegs

             

             

            It is possible to create a voltage vector that rotates in time so that essentially a heterodyning effect is made where  the only machine constructed to show this effect is known as the 666 machine. Every 24 cycles out of a total of 465 cycles per second this circling "separated" magnetic field reacts with its input where situations are somewhat easily engineering whereby a portion of the normal alternator function as a generator is reversed and instead a portion of the machine begins to work backwards, instead propelling electrical energy back to its source, whereby this additional voltage then registers on the phase being affected.
            http://www.flickr.com/photos/harvich/8291688443/
            A "third" magnetic interaction between adjacent secondaries in the phase rotation occurs whereby the combined secondary emfs on the ending of the phase rotation completely oppose the primaries magnetic field, and thereby its amperage.
            http://www.flickr.com/photos/harvich/12493185733/
            http://www.flickr.com/photos/harvich/12493133615/
            The opposite pulsing of each secondary source combined together as a meter reading
            332 volt seriesed output taken from "cyclic" secondaries at no field input to alternator.
            Taken from the you tube video

            http://www.flickr.com/photos/harvich/12493457914/
            I have a special  dual bus alternator larger machine that allows me to run two three phase processes at any desired phase angle between them.  Thus it should be possible to engineer these AC superimposed pulses to instead occur near ten hertz, which is said to be the resonant frequency of the earth itself.
            HDN

          • harvich
            For the simple fact that if the sending high frequency signal were completely amplitude modulated at eight-ten hz it has zero input at a certain time frame
            Message 5 of 5 , Oct 28 8:44 PM

              For the simple fact that if the sending high frequency signal were completely amplitude modulated at eight-ten hz it has zero input at a certain time frame when any recieving stations tuned to the same high frequency as grounded secondaries would be receiving the bounce electrical echo from the planets dimensions via that input. Amazingly this actually indicates that a sort of "magical" input freq can be tried in unorthodox methods to resonate the earth. To do this we probably need big machines. A heterodyning method has been developed where an extra cycle by (3 phase mutual induction methods) from a rotating phasor in time can be developed whereby every 24 cycles an extra beat is combined with the original frequency. here is a scoping showing that effect;

              Vector sum of line input and rotating time vector

               

            Your message has been successfully submitted and would be delivered to recipients shortly.