Loading ...
Sorry, an error occurred while loading the content.
 

Re: TurboCNC configuration

Expand Messages
  • jeremy youngs
    g20 or g21? did you put a . after your feed rate? did you use g1 to call up linear interpolation ? I.E is your g code solid? -- jeremy youngs
    Message 1 of 9 , Feb 18, 2013
      g20 or g21?
      did you put a . after your feed rate?
      did you use g1 to call up linear interpolation ?
      I.E is your g code solid?
      --
      jeremy youngs
    Your message has been successfully submitted and would be delivered to recipients shortly.