Loading ...
Sorry, an error occurred while loading the content.
 

Re: FT-7800 to Radio connector cable

Expand Messages
  • kb4pzo
    Larry, Thanks much, always good to have another set of eyes look things over. Also noted regarding NOT setting the HT jumper. Tim
    Message 1 of 3 , Nov 22, 2009
      Larry,

      Thanks much, always good to have another set of eyes look things over. Also noted regarding NOT setting the HT jumper.

      Tim

      --- In tracker2@yahoogroups.com, "k7ybz" <k7ybz@...> wrote:
      >
      > Tim,
      >
      > Wiring looks good. Just make sure you do not have the HT jumper set inside the OT2.
      >
      > Larry
      > K7YBZ
      >
      > --- In tracker2@yahoogroups.com, "kb4pzo" <kb4pzo@> wrote:
      > >
      > > After reviewing the documentation here is what I've come up with for a cable to connect my radio (Yaesu FT-7800) Data Jack to the OT2m "Radio" connector. Any feedback would be greatly appreciated especially if you already have a OT2m working with a FT-7800 or FT-8800.
      > >
      > > OT2m pin 1 Audio out to FT-7800 pin 1 Packet Data Input
      > > OT2m pin 2 no connection
      > > OT2m pin 3 PTT out to FT-7800 pin 3 PTT (Gnd to xmit)
      > > OT2m pin 4 no connection
      > > OT2m pin 5 Audio in to FT-7800 pin 5 1200 bps Packet Data Output
      > > OT2m pin 6 Ground to FT-7800 pin 2 Signal Ground
      > > OT2m pin 7 no connection
      > > OT2m pin 8 no connection
      > >
      > > Thanks in advance,
      > > Tim
      > > KB4PZO
      > >
      >
    Your message has been successfully submitted and would be delivered to recipients shortly.