Loading ...
Sorry, an error occurred while loading the content.

Re: [tracker2] Re: Configuration program updated

Expand Messages
  • Scott Miller
    It s actually sending 1 HDLC FLAG character for each delay unit, so 8/1200 = 6.66 ms per unit, 166.66 ms for a setting of 25. I ll make a note to myself to
    Message 1 of 11 , Jun 2, 2009
    • 0 Attachment
      It's actually sending 1 HDLC FLAG character for each delay unit, so
      8/1200 = 6.66 ms per unit, 166.66 ms for a setting of 25. I'll make a
      note to myself to fix the conversion factor in otwincfg.

      Scott

      Manfred wrote:
      >
      >
      >
      > Hi Scott!
      >
      > I'm still a little bit confused with the different TXDELAY values.
      >
      > My TXDELAY setup for the T2:
      > Config programm = 100ms; cmd txdelay reports 25.
      >
      > With the conversion factor of 1/150s 25 would be 167ms.
      >
      > Which value is wrong - config program or commandline?
      >
      > 73 de Manfred,OE7AAI
      >
      > --- In tracker2@yahoogroups.com <mailto:tracker2%40yahoogroups.com>,
      > Scott Miller <scott@...> wrote:
      > >
      > > Oh yeah... I forgot about the conversion factor. There's some unit
      > > conversion going on in the config program that's a throwback to the old
      > > setup. I may wind up adjusting the display a bit again to make it
      > > reflect some useful unit of measure, or I could just omit the conversion
      > > to make it consistent with the terminal. The terminal doesn't do unit
      > > conversions to save code space.
      > >
      > > Scott
      > >
      > > Keith VE7GDH wrote:
      > > >
      > > >
      > > > I wrote...
      > > >
      > > > > I got to playing around with TXDELAY. I won't say what I had
      > > > > it set to previously, but I tried TXDELAY 3 and had some success,
      > > > > but backed it off to 10. Can you confirm that the setting is x 10 ms?
      > > >
      > > > OK... now that I've found the TXDELAY in the config program, I set
      > it to
      > > > 100 ms in the config program. When I interrogate it in a terminal
      > > > program, it comes back as 25. Is there any documentation to
      > indicate the
      > > > units when set via a terminal program. Perhaps the manual could be
      > > > updated sometime to indicate this.
      > > >
      > > > Now I'm really getting confused. In both profile 1 & 2, using
      > > > otwincfg.exe, the TXDELAY is set to 100. When I interrogate it using a
      > > > terminal program, it comes back as 25. Any ideas or explanations?
      > > >
      > > > 73 es cul - Keith VE7GDH
      > > > --
      > > > "I may be lost, but I know exactly where I am!"
      > > >
      > > >
      > >
      >
      >
    Your message has been successfully submitted and would be delivered to recipients shortly.