Loading ...
Sorry, an error occurred while loading the content.
 

Firmware build 53910

Expand Messages
  • scott@opentrac.org
    Power control is now working. The command has been changed a bit, though. It s a single commmand now, POWER , and it can be ON, OFF, or a delay. ON forces
    Message 1 of 1 , Jun 29, 2006
      Power control is now working. The command has been changed a bit, though.
      It's a single commmand now, 'POWER', and it can be ON, OFF, or a delay.

      ON forces the power output on, OFF forces it off. This lets you use the
      high side switch to manually control a DC load. Setting it to a numeric
      value makes the radio power control option function as usual, where it waits
      the specified number of seconds for the radio to power up before
      transmitting.

      The Garmin protocol handler has been restructured - parts of it that were
      executed in interrupt context got too big and slow and needed to be executed
      in the main program loop.

      Scott
    Your message has been successfully submitted and would be delivered to recipients shortly.