Re: Firmware woes yet again
- Thanks for the reply EM. That wasn't it but I keep whacking it with
the ball peen hammer until it took.
Who knows ! I wish the manual was better by now. The product is good
though... once it "takes".
--- In firstname.lastname@example.org, "EM Sharp" <wa2ysm@...> wrote:
> Check to make sure you have not checked the "do not transmit if
> voltage is less than XX" option. I left a few bones beside that trail.
> --- In email@example.com, "sam_n1nap" <n1nap@> wrote:
> > If I flash the firmware, the radio, using Hperterminal and DISPLAY
> > shows that it's all there.
> > However the radio will not transmit ! It receives.
> > We have profile switching off, and have it set to CONFIG 0 as
> > suggested last year.
> > This is the same problem we had last year here when we first flashed
> > it when it was new.
> > It has been fine but I thought it was time to update it now.
> > I connect the cable, start OTWINCFG, click CONNECT, load the firmware,
> > load my settings, quit OTWINCFG, disconnect the cable and turn the
> > radio back on. The GPS locks and nada.
> > Ditto if I restart the radio before doing the settings WRITE, and
> > going through the cable connect procedure.
> > Matt WV1K