Loading ...
Sorry, an error occurred while loading the content.

Re: [tracker2] Re: header pins

Expand Messages
  • Scott Miller
    Ground. It has a pull-up resistor to 5 volts, so you just need to pull it low. Scott
    Message 1 of 4 , Apr 20 11:51 AM
    • 0 Attachment
      Ground. It has a pull-up resistor to 5 volts, so you just need to pull
      it low.

      Scott

      pjaopjaopjao wrote:
      >
      >
      > Hi!
      >
      > So to switch between config we need an RJ11 jack.
      >
      > The question is, what we need to wire? Pin 6 and ?
      >
      > Thanks all,
      > Paulo
      >
      > --- In tracker2@yahoogroups.com <mailto:tracker2%40yahoogroups.com>,
      > Scott Miller <scott@...> wrote:
      > >
      > > The CFG input is on pin 6 of the front panel RJ11 jack.
      > >
      > > Scott
      > >
      > > Simon wrote:
      > > >
      > > >
      > > > Hi All
      > > >
      > > > I expect this has already been asked. In the ot2m (surface mount)
      > unit
      > > > I would like to fit a switch to swap between con fig 1 and config
      > 2
      > > > which of the jumper pins would do this?
      > > >
      > > > Simon
      > > > 2e0pea
      > > >
      > > >
      > >
      >
      >
    Your message has been successfully submitted and would be delivered to recipients shortly.