- More modifications to the console. New commands:
MONITOR - same as in the KPC3.
WAYPOINTS - turn waypoint output on or off.
CONFIG x - select profile to edit
IMPORTANT!!! The monitor and waypoint options will default to OFF unless
you load the configuration from scratch! And you can't set them in the
config program yet.
CONFIG should be set to 0, 1, or 2. 0 (default) means all commands apply to
whatever profile is in use. Select 1 or 2 to specify a particular profile
to edit. For example:
comment This is profile 1.
comment This is profile 2.
All configuration commands are still write-only - there's no read function
- I've updated the firmware again - that last release had a glitch that would
cause the DISPLAY command to enter calibrate mode.
Fixed that, and modified the SMARTBCON command so that it now takes the
SmartBeaconing settings. The format is:
SMARTBCON <low speed> <high speed> <low rate> <turn angle> <minimum
Speed units aren't converted yet, so the settings accept native units which
work out to about 1/1.397 mph. The high speed transmit rate is just the
INTERVAL setting and is omitted here.