Loading ...
Sorry, an error occurred while loading the content.
 

Re: [tracker2] Re: Voltage question

Expand Messages
  • Scott Miller
    You should be able to get the actual voltage by multiplying by 1.3333. Sounds like that matches with your actual readings. Scott
    Message 1 of 5 , Sep 28, 2007
      You should be able to get the actual voltage by multiplying by 1.3333.
      Sounds like that matches with your actual readings.

      Scott

      Bryan A. Thompson wrote:
      >
      >
      > I have a Proto E and my voltage shows 9.5V when I supply 12.6V. A
      > clue from Scott was that I could "swap out the 20K resistor with a 30K
      > resistor" and resolve the problem.
      >
      > Bryan A. Thompson
      > bryan@... <mailto:bryan%40batee.com>
      >
      > --- In tracker2@yahoogroups.com <mailto:tracker2%40yahoogroups.com>, Dan
      > Zubey <dan.zubey@...> wrote:
      > >
      > > I have my tracker set to go into profile 2 when I start moving faster
      > > than 10kph, and to flop back to profile 1 when I stop and the
      > voltage to
      > > the tracker falls under 12.9 volts (i.e. I turn off the engine, and
      > > haven't plugged the power supply in).
      > >
      > > Now, when I'm using the test program to monitor what the T2 thinks the
      > > voltage is, and it's jumping about around 10 volts when it should be up
      > > near 14. I remember Scott saying something about that the next code
      > > release might fix something in regards to the voltage reading...am I
      > right?
      > >
      > > Also, how do I tell the tracker to just keep the power to the radio on
      > > all the time on the profile 2 tab?
      > >
      > >
      > > -Dan N7NMD
      > >
      >
      >
    Your message has been successfully submitted and would be delivered to recipients shortly.