- Is anyone on the list running a T3-Micro they got at Dayton? I haven't
heard much feedback so far. I've got the next batch of boards in and I
want to make sure everything's working right on the last batch before I
make these available.
- I'm still experimenting on this end. I've had some luck casting and machining urethane resin for thin-wall parts, but the process is too slow for production. Some day I might get an injection mold made, but that would be a minimum of about $4000 for this project.
On 8/16/2013 5:47 PM, wellmanl wrote:
Has anyone found anything to house the micro other than
tape or maybe shrink wrap?
- I am using the housing from a fried USB DVB-T/RTL-SDR receiver dongle that I got from an eBay seller last year. It's long enough that the board and plug (without the plug's shell) will fit. The original antenna connector hole is in the end opposite the USB connector. I put a rubber grommet in this to pass the wire that goes to the radio. To keep everything in place I can use a piece of foam inserted in the empty space beside the plug. There are a number of holes in the housing so it's easy to see the light from the LED.
I haven't yet wired the plug but it makes a nice assembly. I'm using a USB battery to power the thing when it's not connected to a computer.
--- In email@example.com, "wellmanl" <wellmanl@...> wrote:
> Has anyone found anything to house the micro other than
> tape or maybe shrink wrap?
I tried loading the firmware from the web into my T3-Micro yesterday
and ran into a problem. It complained of an invalid address. I grabbed
the file from the firmware directory and it loaded up just fine. The
web file might be corrupted somehow.
I tried 3 times and got the same results.