On Wed, May 9, 2012 at 3:10 PM, joe@...
> It is not clear to me how to do any of that with a *OT3M*.
> I already have it sending voltage telemetry, which is a built in function.
> Where would you configure the other parameters?
The page I sent you do describes how to get the most telemetry out of
the OT2m. The section at the bottom of the page describes the
telemetry definitions needed to set up the labels, units, equations,
bit definitions, and project name.
I'll have to create a new section describing the telemetry interface
on the OT3, and how to interface, but I was not suggesting adding
other telemetry, but rather just defining what you currently have.
I just went and set up your definitions for you.
2012-05-10 08:13:51 MDT: VE6SRV>APWW09,TCPIP*,qAC,T2SPAIN2::N3HGB-5
2012-05-10 08:14:20 MDT: VE6SRV>APWW09,TCPIP*,qAC,T2SPAIN2::N3HGB-5 :UNIT.Volts
2012-05-10 08:14:49 MDT: VE6SRV>APWW09,TCPIP*,qAC,T2SPAIN2::N3HGB-5
2012-05-10 08:15:40 MDT: VE6SRV>APWW09,TCPIP*,qAC,T2SPAIN2::N3HGB-5
:BITS.11111111,Joe's Hole in the Water
Now the graphs on aprs.fi have labels, units, and are scaled to real