Re: [tracker2] Anyone tried using OT2 with a PowerSwitchTail
- Aha, so you are switching other equipment on and off with the POWER
command. Have a look at the photos section of the Yahoo group to see
the I/O that I have on my digipeaters. There's also a quick hack job
page describing it a bit on the wiki. It's not linked in anywhere yet,
but you can find it searching on "Site Telemetry". I brought the
switched power out of the OT2 and am driving a relay with it. This is
just to make it a little more fool proof, in case someone else tries
to connect into the output. The OT2 contacts are connected directly to
the supply voltage the OT2 runs on, and if someone were to connect
something other than 12 volts to it, the magic smoke might escape.
Hopefully you are thinking about switching other equipment with the
power cord, and not cycling power to the OT2 itself. You'll be
shooting yourself in the foot with that trick.
On 9/30/11, djhuff@... <djhuff@...> wrote:
> Yes, I understand the tracker equipment runs on 12V. Mine at home is
> running fine.
> However, I was thinking of using this on the power control output pin.
> using a manual POWER ON/OFF command over the air would avoid me having to
> drive all the way out to the repeater site to power cycle equipment. And
> using an isolated 120V device means I do not have to run 120 into the
> OT2m. Having a digipeater as a poor mans burglar alarm and temp sensor
> saves me lots of effort.
> Dave W0IM
> From: James Ewen <ve6srv@...>
> To: email@example.com
> Date: 09/30/2011 11:12 AM
> Subject: Re: [tracker2] Anyone tried using OT2 with a
> Sent by: firstname.lastname@example.org
> On Fri, Sep 30, 2011 at 9:34 AM, <djhuff@...> wrote:
>> I have an APRS installation that has to look neat enough to
>> keep electricians happy. So has anyone tried using a OT2 or
>> OT2M with a PowerSwitchTail II ?
> I haven't used such a device, but perhaps you might enlighten us as to
> what it is you are using this powerswitch tail for with an OT2.
> Generally the OT2 connects to a radio, which is connected to an
> antenna. The radio and OT2 most likely run off of a 12 volt source.
> What are you doing with the 120 volt switch?