Loading ...
Sorry, an error occurred while loading the content.

Re: Correct Jumper Settings & TX level for a HT

Expand Messages
  • h_r_72
    Thank you very much!
    Message 1 of 3 , Apr 25, 2011
    • 0 Attachment
      Thank you very much!

      --- In tracker2@yahoogroups.com, "captnkliegle" <kliegle@...> wrote:
      >
      > TX audio level can be set by ear using another 2M radio. As long as its not distorting, i.e. too much audio.
      >
      > Years ago I had connected an VX-6R to an OT1+, using the following
      > connections and part, here's my review:
      > https://www.argentdata.com/catalog/product_reviews_info.php?products_id=67&reviews_id=10&osCsid=b23e516d79b839e2145e6baa9e4d531e
      >
      > I tend to use external resistor/capacitors in my setups, sice the same unit may be used with a mobile rig today, and HT next week, and back to a mobile rig. So no opening up the case to remove jumpers, etc. The resistor and cap fit easily into the DB-9 shell. Values of resistor and cap are portrayed on page 11 of the FT-60R ops manual, as well as how the two are wired in parallel to the mic pin.
      >
      > So... if no audio is sent, but the rig is in TX mode... either the audio line is shorted to GND (no capacitor) or not enough audio going into radio. (level adjust).
      >
      >
      > Kriss KA1GJU-X
      >
      >
      >
      >
      > --- In tracker2@yahoogroups.com, "h_r_72" <rosendeh@> wrote:
      > >
      > > Hello Everyone!
      > >
      > > I have some newbie questions, I apologize if some concepts are not correct.
      > >
      > > I want to set up OT2M jumpers for a Yaesu FT60R. It were set up like this: HT jumper set on, all others were removed.
      > > Is it correct? because it seems that many packets are dropped. I can see that RX led is on very often but many packets are not decoded. Which is a correct ratio? EQ jumper was set on and off but I could not appreciate any significant difference. I checked packets also with passall parameter set to on. Any idea?
      > >
      > > How can I set the correct Tx level for my HT, because I can't hear nothing with the cable I bought.
      > >
      > > Thanks in advance.
      > >
      >
    Your message has been successfully submitted and would be delivered to recipients shortly.