Re: Problem getting cmd prompt
- Both port A and port B are set in "Auto" mode.
Baud rates on both are 4800.
Flow control is disabled on PC side.
My PC is connected through an iogear usb-serial converter.
The funny thing is that it seems to work for the first time after power on, but then fails later, when I cycle the power on the radio.
My tracker2 is mounted in a T2-301D radio, so I don't have LEDs on the front, but the power led comes on and transmit led blinks.
If others are not having this problem, then this must be something with my config, but I just can't figure it out yet.
Thanks for your help
--- In email@example.com, Scott Miller <scott@...> wrote:
> What mode is port A set to? What baud rate? Try disabling flow control
> in your terminal program if you haven't already. Do the front panel
> LEDs blink every time it starts up?
> On 2/2/2011 10:54 PM, rogerstager wrote:
> > I am having intermittent problems getting a cmd prompt. I recycle the
> > power and press enter several times, but I do not get a prompt.
> > Sometimes it works on the first attempt, but fails at all subsequent
> > attempts. I have tried with and without the GPS attached.