PTB2 / PTD2 NOT WORKING
- Looking at the schematic for OT2-ProtoC I find that the command
OUTPUT1 is supposed to control U2 pin-1.
The OTWINCFG program incorrectly refers to that as PTB2 OUTPUT, which
was used on OT1. According to the schematic it should be called PTD2
Using either the OTWINCFG program or the OUTPUT1 ON/OFF console
command seems to have no affect on this output. Its stays low (0.0v &
will haul down an LED) and its impedance is over 1meg so there is no
Using software Tracker2 Firmware Build 54010 on OT2 ProtoC.
Since this pin is wired directly to X2-2 the radio port, and not thru
a jumper, special mention of this should be made in the docs.
Anyone got this working?