Loading ...
Sorry, an error occurred while loading the content.

15419Re: OT1 USB problems...

Expand Messages
  • ricer3dad
    Apr 2, 2013
      I tried the serial port using a USB/serial converter (one that I use for my older 0T1+ device) from my computer but was not able to get anything out of OT1-USB device. :(

      _____________________________---

      --- In tracker2@yahoogroups.com, Scott Miller <scott@...> wrote:
      >
      > Sounds like maybe the USB bootloader got clobbered, but serial might
      > still work. Try connecting with a serial port rather than USB.
      >
      > Scott
      >
      > On 4/1/2013 6:54 PM, ricer3dad wrote:
      > > Not sure what I've done to my OT1 USB... but hope it's not dead.
      > >
      > > I use Linux mostly (Ubuntu 10.10), so I followed the usb wiki to set up
      > > the symbolic link and successfully ran the otwincfg.exe (operating under
      > > wine). It recognized the device displayed the default settings.
      > > I was also able to connect to it with the Linux cu utility (cu -l ttyACM0).
      > >
      > > Well, I noticed that there was a flash file on the Argentdata website
      > > for the OT1 USB (dated January 30, 2012), so I downloaded the file and
      > > used the otwincfg program to flash the file into the OT1 USB. But
      > > instead of a "successful load" message I got an error message about a
      > > bad data value. So i tried it again but this time I had the otwincfg
      > > program retrieve the flash file from the web. The same error message
      > > appeared. So I closed the program and powered off the device by
      > > unplugging the USB from the OT1 and then plugged it back in again.
      > >
      > > Now when I plug the USB in, the LED indicator is solid green and it
      > > stays on as long as the USB is connnected. I can't seem to get the
      > > otwincfg file to recognize the device. (But doing a terminal command
      > > lsusb shows that the usb is recognized: Bus 003 Device 006: ID 134a:9000)
      > >
      > > Instead of the USB power, when I plug in the +12VDC the LED flashes red
      > > at approximately a 1 Hz. rate. While the +12VDC is applied, attaching
      > > the USB to my Linux computer still doesn't recognize the device... but
      > > it still flashes red at 1Hz.
      > >
      > > Performing dmesg shows:
      > > [ 2399.096034] usb 3-1: new full speed USB device using uhci_hcd and
      > > address 6
      > > [ 2404.279184] cdc_acm 3-1:1.0: This device cannot do calls on its own.
      > > It is not a modem.
      > > [ 2404.279221] cdc_acm 3-1:1.0: ttyACM0: USB ACM device
      > >
      > > Any suggestions/comments/thoughts would be greatly appreciated.
      > >
      > >
      >
    • Show all 6 messages in this topic