15272Re: OT3m Build 56330 strange profile switching
- Feb 23, 2013Scott
I hope you received my config and the console output.
Where can I find Tracker3 beta build 56294, I need that version until you find
something "strange2 on version 56330
--- In email@example.com, Scott Miller <scott@...> wrote:
> Can you save your configuration to a file and send it to me off-list?
> I'll see if I can replicate the problem.
> A sample of the console output might be useful, too. Check that you've
> got the baud rate set properly.
> On 2/18/2013 1:54 PM, Thomas wrote:
> > My OT3m switch to profile 2 without GPS fix after 2-3 hours uptime?
> > Normally my OT3m are sending a beacon every 25 minutes when the GPS is
> > off, Profile 1 has
> > Fixed, Save and Don´t require GPS fix marked. Profile 2 has GPS marked.
> > In the Profile Switching Setup: switch to Profile 2 when: GPS fix =
> > Valid and switch to profile 1
> > when GPS Fix = Invalid.
> > Suddenly after 2-3 hours uptime the tracker switch to Profile 2 (still
> > no GPS input) and start sending a beacon without positions every 35
> > second. This behavior keeps on until I start the GPS and normal packets
> > with positions are sent. (Then after 2-3 hours without GPS the problem
> > starts again)
> > Power off/on will not fix the problem, the tracker is still in Profile 2.
> > A connected serial console (Putty) writes strange characters?
> > I have tested two different OT3m with same results
> > Build 56133 works ok
> > Thomas SM0YOS
- << Previous post in topic