Loading ...
Sorry, an error occurred while loading the content.

15201Re: OT3m Power Control hang up

Expand Messages
  • Thomas
    Feb 4, 2013
      I am sending the commands from the serial console and I have the Power Control enabled in the config. I want to have the same function as for
      sending a beacon: Power on, beacon sent, Power off.
      Power on, message sent, Power off

      /Thomas SM0YOS

      --- In tracker2@yahoogroups.com, James Ewen wrote:
      >
      > On Mon, Feb 4, 2013 at 12:02 PM, Thomas wrote:
      >
      > > I am running an OT3m with firmware 56294
      > > When sending a message with the SEND command the OT fire up the Power
      > > Control PS with 12 volt. But when the message has been sent Power Control
      > > will not go down. If I send a beacon, power control will go down.
      > > Same sitation will happen when I send a APRS message with CMD xxxx
      >
      > How are you sending these commands? Direct from the keyboard, via a
      > script, or some other means?
      >
      > Is the "fire up the Power Control PS" a command you are sending or
      > something different?
      >
      > If you send a POWER ON command, the output will stay latched on until
      > you send a POWER OFF command.
      >
      > If you send POWER 30, the power output will be enabled for 30 seconds.
      > The time value allowed is from 0 - 255 seconds.
      >
      > --
      > James
      > VE6SRV
      >
    • Show all 11 messages in this topic