15146Home built cable question help
- Jan 19, 2013I had built a cable for my tracker a while back but I found out about the ot3m -- bought it and ready to get it up and running !!
I had built it for my htx 242 based off the byonics m7p cable -- http://www.byonics.com/cables/m7p.png
It has pin 7 12v and pin 6 as ground -- will this cause any issues when I plug it into the ot3m or should I take those pins out of my connector
Here is what I built
I added power poles to the serial side and the rj45 side du to the radio being installed in the back of the truck and the ot3m in the front of the truck -- used a cat6 cable will be connected to the nuvi350 with the fmi cable
Any issues y'all could think of by leaving the pin 6 & pin 7 in -- can you power the ot3m that way or not -- I skimmed the manual for an answer but I think I'll skim again
- Next post in topic >>