Loading ...
Sorry, an error occurred while loading the content.

14782Re: [tracker2] T3-135: USB not working

Expand Messages
  • Scott Miller
    Sep 8 8:38 PM
    Here you go.

    Scott

    On 9/6/2012 7:44 PM, Suryono Adisoemarta wrote:
    > Scott,
    >
    > The board is active as it is working as a digi (configured thru the DE9
    > port).
    >
    > I'll double check the solder joints under the USB port.
    > Can I have the schematic of T3-135? So I can check continuity end-to-end.
    >
    > Thanks, Paulus
    >
    > Sent from my iPhone4
    >
    > On Sep 7, 2012, at 12:25 AM, Scott Miller <scott@...
    > <mailto:scott%40opentrac.org>> wrote:
    >
    > >> Is there a switch, on otwinconfig, to enable the USB port?
    > >> Any low-level method to check the USB port?
    > >
    > > Nope, it should just work. I'd look closely at the pins on the board
    > > side of the USB port. They're all tested before they ship, but
    > > sometimes the solder doesn't flow well under the pins and there's a
    > > possibility it had a bad joint and cracked when it was plugged in.
    > >
    > > You do need to make sure the radio is in data mode, too - otherwise the
    > > board won't be powered up.
    > >
    > > Scott
    > >
    > >
    > >
    > > ------------------------------------
    > >
    > > Yahoo! Groups Links
    > >
    > >
    > >
    >
    >
  • Show all 8 messages in this topic