Loading ...
Sorry, an error occurred while loading the content.

1412Re: Proto C question

Expand Messages
  • k9sarfrog
    Dec 31, 2006
    • 0 Attachment
      I'm going from the proto-board to null modem serial connector
      straight into serial port for the computer. I can flash the firmware
      and save settings with otwincfg.exe.


      --- In tracker2@yahoogroups.com, "k0yg" <mpatton5280@...> wrote:
      >
      > Hi,
      >
      > If you are using a USB serial port adapter, you might try
      connecting
      > directly to the serial port on the PC. I've had my USB adapters
      > cause issues like this.
      >
      > Mark
      >
      >
      > --- In tracker2@yahoogroups.com, "k9sarfrog" <both@> wrote:
      > >
      > >
      >
      ______________________________________________________________________
      > > i tried both hyperterm and CRT. And got nothing.
      > > When I use the setup program or the firmware update, it pushes
      > those.
      > >
      > > I am using a 12v 800mA powersupply. I doubt that could be the
      > problem.
      > >
      > > Ideas?
      > >
      > > 2b. Re: Proto C question
      > > Posted by: "Scott Miller" scott@ n1vg
      > > Date: Sun Dec 10, 2006 3:44 pm ((PST))
      > >
      > > That sounds like it's not starting the oscillator properly. Are
      > you
      > > able to
      > > get to the command console?
      > >
      > >
      > > _____
      > >
      > > From: tracker2@yahoogroups.com [mailto:tracker2@yahoogroups.com]
      On
      > > Behalf
      > > Of k9sarfrog
      > > Sent: Sunday, December 10, 2006 3:22 PM
      > > To: tracker2@yahoogroups.com
      > > Subject: [tracker2] Proto C question
      > >
      > >
      > >
      > > I don't think it's transmitting. I have a ICOM IC-F3 handheld. I
      > have
      > > both the double tx/rx cable and the single.
      > >
      > > when i add power to the ProtoC board i get very brief green at
      > which
      > > point it swtiches to red.
      > >
      > > otwincfg is able to read/write, i grabbed the latest firmware
      from
      > > the
      > > files section and uploaded it. all I did is changed the callsign,
      > and
      > > switch it to a fixed position.
      > >
      > > Any suggestions on next step?
      > >
      > > Thanks
      > > Chris
      > > K9RMA
      > >
      >
    • Show all 17 messages in this topic