Loading ...
Sorry, an error occurred while loading the content.

Variac Operation Changes BRS Neon Operation.

Expand Messages
  • harvich
    One would assume that 27 volts from a variac inputed through a 4/1 step up transformer, which then becomes roughly equivalent to household voltage of 120
    Message 1 of 1 , Jun 7, 2002
    • 0 Attachment
      One would assume that 27 volts from a variac inputed through a 4/1
      step up transformer, which then becomes roughly equivalent to
      household voltage of 120 volts, would be the same thing as actually
      using that household voltage. However it is not, as far as the BRS
      is concerned. The process then blinks rapidly, where the number of
      blinks per second correspond to the resonant frequency of the earth
      at between 8 to 12 hz, or between 16 and 24 discharges per second.
      This was actually measured a number of years ago by VHS tape
      recording the process and counting the blinks of on and off over a
      number of frames, where this was shown to be ~ 24 blinks per second.
      Now the reason that this was not thought to be a function of earth
      resonance, was the determination that perhaps it is the actual length
      of the bulbs that determines how long the discharge takes to blink on
      and off. This may be true since last year when a 100 ft copper
      tubing was partially buried in the low section of garden ground, the
      small neon connection then seemed to blink very much faster, so fast
      in fact that it appeared to be going at even 100 blinks or so per
      second, or it may have even been blinking in accordance to the 60 hz
      power grid signal. Additionally when the small bulb is placed
      directly across the BRS midpoints with variac control of the process,
      the blinking can be regulated by the voltage input, where the
      blinking can be made to go facster by increasing the variac voltage.

      In any case here, what the variac accomplishes through its two
      transformers is to isolate the process from ground. This then
      prevents the blinking from occuring. When the process is directly
      driven from a wall outlet the blinking does occur at the rate
      mentioned. Here is a jpeg of the blinking process caught with the
      camera catching the on portion of a blink.

      BRS Neon blinking process without intervening variac regulation
      http://groups.yahoo.com/group/teslafy/files/BRS/Dsc00218.jpg

      Sincerely HDN
    Your message has been successfully submitted and would be delivered to recipients shortly.