- Hi all,
Does any one work with SuperCam software on Taig CNC Mill?
What is the best configuration setup to make it work probably?
I think that there are other commands not included in the manual, did
any one handle with??
- I don't use Supercam much any more, but I've still got the software on my
computer. I set mine up to do half stepping, and to use the Taig
quadrature output. Past that I didn't do a whole lot of tuning. I think
I set it to use frequency modulation. I was running it from a 166 MHz
computer, so I think I was pushing my luck a little using frequency
modulation, but it worked.
I don't know about commands not in the manual. I hate to say it, but I
didn't experiment nearly as much as I should have.
On Sat, 1 Feb 2003, anwar addasi wrote:
> Hi all,
> Does any one work with SuperCam software on Taig CNC Mill?
> What is the best configuration setup to make it work probably?
> I think that there are other commands not included in the manual, did
> any one handle with??
> Best Regards,
> To Post a message, send it to: taigtools@...
> To Unsubscribe, send a blank message to: taigtools-unsubscribe@...
> Let the chips fly!
> Your use of Yahoo! Groups is subject to http://docs.yahoo.com/info/terms/
- What Cad/Cam Software are you using to create the G Code?
If you have a choice of post processors which are you using?
Please post the code which isn't working.
[Non-text portions of this message have been removed]