- ... Very cool. Did you have to tap holes into the back of the headstock?Message 1 of 4 , May 11, 2013View Source--- In firstname.lastname@example.org, "GordonR" <blscopes@...> wrote:
> Yes. Check the photos section under "Taig Hybrid Two" to see an installation I did some time ago to fit a Sherline motor to a Taig lathe. The Sherline spindle pulley was bored out to fit the Taig spindle.
Did you have to tap holes into the back of the headstock?
- No. I used flat 10-32 nuts in the T Slot.Message 2 of 4 , May 12, 2013View SourceNo. I used flat 10-32 nuts in the T Slot.