(3)thank you very much thats the closest ive been able to find a pic of it
(4)Precisely, as I understand it anyway. From: email@example.com [mailto:firstname.lastname@example.org] Sent: Tuesday, March 31, 2015 7:21 PM To:
(10)Thanks for the official measurements. I should note that there are at least two errors in the p. 53 figure on the 6K collet in the above referenced HSM
Fetching Sponsored Content...
(3)I manufactured one out ofmild steel. the hole is 1/8in dia. Just make your pin a little bit oversized. It should be about 1/8 in out. If a MT 3 centre
View First Topic Go to
Loading 1 - 4 of total 4 topics