Loading ...
Sorry, an error occurred while loading the content.
 

Re: Identify Missing Parts

Expand Messages
  • leibushor
    I uploaded pictures under Photos -- 10R Lathe .
    Message 1 of 18 , Feb 12, 2013
      I uploaded pictures under "Photos --> 10R Lathe".

      --- In southbend10k@yahoogroups.com, Nelson Collar wrote:
      >
      > Pictures would be nice. Like they say one picture is worth a thousand words.
      >
      >
      > ________________________________
      > From: leibushor
      > To: southbend10k@yahoogroups.com
      > Sent: Tuesday, February 12, 2013 12:46 PM
      > Subject: [southbend10k] Re: Identify Missing Parts
      >
      >
      >  
      >
      > Thank you again.
      > I think my lathe is 10R (?) , which is supposed to be like the 10L but with slightly smaller spindle. But I might be wrong.
      > Thank you for your reply.
      >
      > Asaf
      >
      > --- In southbend10k@yahoogroups.com, anthrhodes@ wrote:
      > >
      > > Asaf,
      > >
      > > I just realized That your lathe is a 10K and I was specifically referring
      > > to details for a 10L. When I said the internal gears were 14 DP, I'm certain
      > > that doesn't apply to your gearbox, however everything else I've said is
      > > valid. The tooth counts are the same for both 10K and 10L and the question
      > > of which gear in the cone provides final drive is still valid. If you can
      > > determine which gear in the cone drives the gear on the leadscrew the correct
      > > screw gear can be determined. At this point the most likely possibilities
      > > are 56 or 40.
      > >
      > > My apologies for the confusion.
      > > Anthony
      > > Berkeley, Calif.
      > > *********************************************
      > >
      > > In a message dated Thu Feb 7, 2013 11:06 pm (PST), leibushor writes:
      > >
      > > Thank you very much Anthony. That helps a lot. Unfortunatly it sounds like
      > > I will need to take the gear box out to determine the leadscrew and its
      > > mating one. If your gear box is like mine (70 ratio?) what are those gears in
      > > your box? Can I assume mine are the same?
      > >
      >
    Your message has been successfully submitted and would be delivered to recipients shortly.