- View SourceI'm getting close to powering up my Force with the new CA100's. I need to know the sequence for energizing the various circuits so I don't hurt anything. I've read of things like the amp hour meter burning up and I would sure like to avoid that.
- View SourceI don't think you have to connect things in any particular order. I
just plug in the service disconnect and the power connector to the
controller without worrying about order.
- View SourceMake sure any com loop and power on your bms are the last to connect and first to disconnect if pulling power. Other than that I've always done
Controller then service loop,bms com, bms power
Off bms power, com,service loop , controller
So far nothing blown. Must have done it 30 times..
Sent from my iPad
On May 5, 2013, at 10:36 AM, Ken Olum <kdo@...> wrote:
> I don't think you have to connect things in any particular order. I
> just plug in the service disconnect and the power connector to the
> controller without worrying about order.
[Non-text portions of this message have been removed]