Loading ...
Sorry, an error occurred while loading the content.

7351Re: [solectria_ev] E-10 controller settings

Expand Messages
  • William Swann
    Jul 5 8:33 PM
    • 0 Attachment
      Great advice. Thank you.

      Thanks, Bill Swann
      www.promotingevs.com
      www.watt-tracker.com


      On Jul 5, 2011, at 10:03 PM, Wolf <wolf@...> wrote:

      > The actual position of the switch depends on the wiring of the motor.
      > The switch swaps the A/B lines on the motor's encoder.
      >
      > If you apply throttle and the motor shutters,
      > Then swap the motor phase.
      > The motor should now spin.
      >
      > If you can only go 10 MPH in Forward,
      > Then swap the phase back, and flip the switch.
      > The motor should now spin.
      >
      > Wolf
      > *Wags his tail*
      > www.wolftronix.com
      >
      > On Mon, Jul 4, 2011 at 4:53 PM, William S <william.swann2@...> wrote:
      >
      >> **
      >>
      >>
      >> I am re-assembling the E-10 controllers. I note a switch in the section of
      >> the controller, where the battery voltage and 3 phase outputs connect. It is
      >> shown on page 25 of 27 of the document entitled "AMCxxx_17.pdf", in the
      >> files section. It is labeled "sense of rotation". And the switch appears to
      >> have an a and b position. I assume it determines the rotation direction of
      >> the 2 motors. Does anyone know the switch positions for the 2 controllers? I
      >> could check rotation with one motor powered, then the other, and verify that
      >> the directions are the same and forward when the forward motion selector is
      >> selected. Thanks in advance.
      >>
      >>
      >>
      >
      >
      > [Non-text portions of this message have been removed]
      >
      >
      >
      > ------------------------------------
      >
      > Yahoo! Groups Links
      >
      >
      >
    • Show all 3 messages in this topic