Re: [softrock40] Help with CWSkimmer
- I am using CW Skimmer with Softrock Lite II ( crystal oscilator 36 MHz) and IC-737 (second IF for CW 9.0106 MHz ).
I am attaching my CW Skimmer settings screenshots . Hope it will help.
73 Valentinas LY2BOS
At 05:38 PM 1/6/2013, you wrote:
I have Softrock RXTX v. 6.3 on Si570 (USB control) or someone from the group
uses such a set of CW Skimmer?
if someone could tell me of you a hint on how I set CW Skimmer to Softrock
worked with v. 6.3 ...?
what do I type in the LO Frequency, Hz ......?
This is one thing and the other set is the same as CW Skimmer
what to send to the server decode ....?
73 , Jakub SQ8J
If you are using the Si570 this can become a interesting exercise. In the CW skimmer instructions it does a good job of explaining on how to do this, but it does not cover on how to do this with a Si570 Softrock.
It depends on your setup and the software you are using to run the RXTX such as HDSDR or PowerSDR. In HDSDR you can readily see the LO frequency, but in PowerSDR you'll need CFGSR to determine the LO frequency. The key is the CW Skimmer IF HZ setting and finding a reliable source for the verification of what you are tuning to and the setting of the IF HZ setting. I used the ARRL CW Messsage broadcasts held at various times and bands.
I tried VAC and got the same result as through direct I/Q. This link will do a lot to educate you on the settings. http://kc.flexradio.com/KnowledgebaseCategory116.aspx
--- In email@example.com, "Jakub Sarna" wrote:
> Hello all
> I have Softrock RXTX v. 6.3 on Si570 (USB control) or someone from the group
> uses such a set of CW Skimmer?
> if someone could tell me of you a hint on how I set CW Skimmer to Softrock
> worked with v. 6.3 ...?
> what do I type in the LO Frequency, Hz ......?
> This is one thing and the other set is the same as CW Skimmer
> what to send to the server decode ....?
> 73 , Jakub SQ8J