Re: [softrock40] Re: Ensemble II output
- Leonard, I appreciate all of the answers I am getting from everyone. I have checked all of the solder points, reflowed(?sp) each pin of the ICs. One measurement that bothers me is one in which I am supposed to get half of the rail voltage ( 5v). but I get 4.5volts.Anyway, I am, still checking. Thanks for the reply.Junius W5HIR----- Original Message -----From: Leonard McGaritySent: Tuesday, October 30, 2012 6:55 PMSubject: [softrock40] Re: Ensemble II outputDon’t know if this applies to the problem described in this thread, but I too was initially not getting the I/Q signal where it needed to go. Both my PC (on MB sound) and netbook have little/no documentation as to whether a stereo input or not. The netbook is likely mono only, and rather than start poking the 3.5mm stereo I/Q plug into the PC’s sound card ports, posssibly damage, I bought a known stereo input PCI sound card, installed, now it all works great. I use SDR-Radio on both my Ensemble II and SDR-IQ. I find the Si570 must init with CFGSR unless PC is restarted with Ensemble II powered, USB at least connected. The SDR-IQ needs the USB connection cycled unless it too is USB connected/powered at start up. I have a Win 7 32 bit SP1 system and now an Audiophile 192 PCI sound card. Maybe Win 7 has a quirk juggling USB ports/connects, after start, don’t know, but never seen this with other USB devices, eg printers, etc.. Hope something herein helps.. Link, WV4I
Email scanned by PC Tools - No viruses or spyware found.
(Email Guard: 184.108.40.2068, Virus/Spyware Database: 6.20830)
----- Original Message -----
Subject: Re: [softrock40] Re: Ensemble II output
> One measurement that bothers me is one in which I am supposed to get half of the rail voltage ( 5v). but I get 4.5volts.
Anyway, I am, still checking.
Did you mention that?
It could well be your problem.
73 Alan G4ZFQ