- OK. I increased the level to +4 dBm, switched from 30 to 40 to 30M, and
I now have a thin line right at the center of the waterfall. It's
moving slightly over time, but less than 5 Hz. The Rx Noise: is still
red, but varying from -28 to -21 dB during the receive segment.
Of course by resetting the Si-570 under CFGSR I lost what frequency
accuracy I may have had. PSDR 2.0 is still not controlling the Si-570
at all. I can't seem to get it calibrated in SR40 for some reason. So
I'm at whatever the factory setting is, although I needed some
correction when 2.0 was working.
We do this for fun... We do this for fun... We do this for ........
73, Garey - K4OAH
Glen Allen, VA
----- Original Message -----
Subject: Re: [softrock40] Adjust level in Soft Rock light.
>OK I finally got a chance to play again and found the Delta 44 panel. The
>inputs were all the way to the bottom. -144, I raised them to the top of
>the green -13 on the Delta 44 panel and will see how it runs.
In my experience you should not use the mixer.
In my system it introduces phase shift under certain settings.
Just use the default setting in the Patchbay/Router.
Just use the presets.
73 Alan G4ZFQ