Loading ...
Sorry, an error occurred while loading the content.

Re: SR RX/TX 6.3 finished, Questions about setup

Expand Messages
  • Bill P.
    Thanks for pointing this out, guess I just missed seeing it. Well if I didn t screw up anything in the process, it should work. without that jumper it hears
    Message 1 of 3 , Jan 1, 2009
    • 0 Attachment
      Thanks for pointing this out, guess I just missed seeing it. Well if
      I didn't screw up anything in the process, it should work. without
      that jumper it hears my Elecraft KX1 up to 2 feet distance so at least
      Rocky works with the Creative Labs USB Audigy 2 to some degree ...

      Regards ..... Bill K6ACJ

      --- In softrock40@yahoogroups.com, "cesco12342000" <cesco1@...> wrote:
      >
      > > The RX BPF is installed.
      > > The TX board is not installed.
      >
      > > Does the antenna need any jumpers to complete the circuit?
      >
      > Yes, if i remember pin 1 to 5 on the PA connector. Look schematic to
      > verify. Or unsolder the C near ant-connector and re-route directly to
      > ant-hot skipping the pa-filters. That is what i have done.
      >
    Your message has been successfully submitted and would be delivered to recipients shortly.