Loading ...
Sorry, an error occurred while loading the content.
 

Re: [softrock40] Power supplies for the V9.0

Expand Messages
  • Tony Parks
    Hi Cecil, To power the v9.0 receiver you will need a 9 volt to 12 volt DC source at a little over 100 mA. A supply that is free of ground connnections works
    Message 1 of 3 , Nov 29, 2008
      Hi Cecil,
       
      To power the v9.0 receiver you will need a 9 volt to 12 volt DC source at a little over 100 mA.  A supply that is free of ground connnections works best.
       
      73,
      Tony KB9YIG
      ----- Original Message -----
      Sent: Saturday, November 29, 2008 9:58 PM
      Subject: [softrock40] Power supplies for the V9.0

      Any common knowledge about powering the V9.0 board.

      Not usually wild about wall warts but may be OK for this application.

      Just battery power? (cleanest for sure)

      Cecil Acuff
      K5DL

    Your message has been successfully submitted and would be delivered to recipients shortly.