Re: [softrock40] Re: SoftRock RX/TX V6.2 use with USB-I2C?
- Once again, thank you, Tony et al. I had to bow out on you all last
night but here in Michigan we promise to have a great Halloween Day.
Hope the ghouls stay away form the SDR boards!
Tony Parks wrote:
> Hi Bruce,
> You will need to add a 1k pull up resistor to the USB I2C board from
> the DA hole to 5 volts at pin 8 of U1. Paddles may then be connected
> to K1, K2 and Ground holes with K1 connected to the paddles dot
> switch. The PTT input to your v6.2 board is connected to the PTT hole
> on the USB I2C board. A ground connection may also be needed between
> the USB I2C board and your v6.2 board although it will probably be
> made through the soundcard ground between your PC and the v6.2 board.
> Tony KB9YIG
> ----- Original Message -----
> *From:* Bruce Tanner <mailto:bet110@...>
> *To:* firstname.lastname@example.org <mailto:email@example.com>
> *Sent:* Friday, October 31, 2008 12:48 AM
> *Subject:* Re: [softrock40] Re: SoftRock RX/TX V6.2 use with USB-I2C?
> Thanks, Steve. I will check that message out but briefly, how is the
> hook up made with that board? If the answer is in the message just
> me know and you will not have to repeat it.
> vk7oo wrote:
> > Hi Bruce
> > I've got it working with the 20/30m (daughter board) version of the
> > 6.2RX/TX
> > If your interested, read message #25774
> > -Steve VK7OO
> > --- In firstname.lastname@example.org
> > <mailto:softrock40%40yahoogroups.com>, "k2bet1" <bet110@...> wrote:
> > >
> > > Can the USB-I2C synth unit be used on the V6.2 RX/TX boards?
> > know?
> > >
> > > Bruce, K2BET
> > >
> > __________ Information from ESET Smart Security, version of virus
> > signature database 3571 (20081030) __________
> > The message was checked by ESET Smart Security.
> > http://www.eset.com <http://www.eset.com>
> __________ Information from ESET Smart Security, version of virus
> signature database 3572 (20081031) __________
> The message was checked by ESET Smart Security.