Loading ...
Sorry, an error occurred while loading the content.
 

Re: qrp2000 synthesizer

Expand Messages
  • tom_iphi
    Hi Jim, try Microsoft s USBView http://support.microsoft.com/kb/838100/en to check if the USB-device is visible on the USB hub. If it is, then it s a driver
    Message 1 of 3 , Jul 31, 2008
      Hi Jim,

      try Microsoft's USBView
      http://support.microsoft.com/kb/838100/en
      to check if the USB-device is visible on the USB hub. If it is, then
      it's a driver issue. If it's not, then it is a hardware issue.

      73's Tom DG8SAQ

      --- In softrock40@yahoogroups.com, "applewiz67" <robbrown@...> wrote:
      >
      > Hi Jim,
      >
      > Have you installed the driver software correctly? Mine showed up in
      > the windows control panels > hardware list straight away. Also it's
      > probably a good idea to always connect to the same USB port as when
      > you installed the driver.
      >
      > It's unlikely the AVR chip needs reprogramming. Hardware faults on
      > flash micros that make them 'lose' their programs are very rare.
      >
      > -Rob
      >
      >
      > --- In softrock40@yahoogroups.com, "gm3jsx" <gm3jsx@> wrote:
      > >
      > > i have just completed building this kit..usb test went ok.but i
      now
      > > find that the pc will not recognize the board..is it possible
      that i
      > > have lost the info on the chip and it needs re-flashing..
      > > voltages are all ok..any help would be appreciated..
      > > jim gm3jsx
      >
    Your message has been successfully submitted and would be delivered to recipients shortly.