Re: HELP! RXTX 6.2
- --- In email@example.com, "Tony Parks" <raparks@...> wrote:
>reverse power supply polarity problem so you should be ok. When the
> Hi Hank,
> There is a series diode on the RXTX board to guart against the
power supply is connected with the right polarity, what current is
supplied to the RXTX board in RX mode?
>Thanks a million for your quick reply. Decided to walk away from the
> Tony KB9YIG
> ----- Original Message -----
> From: hczerwick
> To: firstname.lastname@example.org
> Sent: Sunday, June 01, 2008 12:56 PM
> Subject: [softrock40] HELP! RXTX 6.2
> Finished my kit yesterday. Did all the prelim tests in the Builders
> notes up to testing the receiver part. Everything checked out.
> Went to hook it to the windows computer with Rocky. I rarely use
> windows as I'm mostly a Linux guy. I do have a second computer here
> with XP on it. Noticed I had driver issues with the sound card. Got
> that straightened around. No luck with the RXTX. Played with the
> jumpers a bit. Still no luck. Put it away for the night.
> Here's the stupid part on my part. I had two bits of end leads from
> caps soldered in the power in part of the board. I had a old end from
> a dead computer fan that fit on there nicely. It was a 3 prong plug.
> Until I hooked the coax up then I had to plug it on backwards for it
> to fit. Well this morning I decided to go back to testing square one
> and in seeing how many mA draw there was I inadvertently reversed the
> So now when you go and test the resistance between + and ground it
> behaves like you are charging a cap up. Starts out low resistance and
> builds until it's off the chart.
> Have I fried the whole works? Or do you think I may have just cooked
> the voltage regulator?
> Any thought appreciated.
> Hank AB2XG
whole calamity of errors that went on here right after breakfast and
take care of some other things while I thought about this whole thing.
Something was not adding up. If you have resistance and apply voltage
there needs to be measurable amperage right? Well not if the fuse in
the meter is blown for some reason. Got that squared away and
everything measured like it should. Got rid of the whole plug thing I
mentioned also, that was nice for building and testing but we're past
that now. So hooked everything back up to the Windows computer and
still nothing. Dug around the junk box and found a old SoundBlaster
Card. Popped that in the computer and tried it and now we're receiving!!!!
So now to get this in an enclosure and see if we can get on the air!!!
Thanks a million again.