Loading ...
Sorry, an error occurred while loading the content.

Topics List

RXTX power supply problem

(8)
Don't feel bad. I've done that before but on a different chip. In my case, I was able to de-solder it and reuse it. So it is possible if you are careful and
bruce_ahler
8
posts
Mar 27

Critical/Experience!!!

(6)
He without scruples wants our rubles. Jim/ND6P
Wolfgang Arnold
6
posts
Mar 27

RXTX ensemble build problems.

(3)
Thanks, Roger, I am not sure whether the 3dB loss in the mixer is that significant. We are talking about 0.7 V RMS input and 0.4 V RMS output through a 5 V
pvrose@btinternet.com
3
posts
Mar 26

Softrock Ensemble II freq 3 khz too high on 40 (6 on 20m, 9 on 21 et

(4)
That did the trick. Somehow calibration got out of whack when I switched computers… All good now. Thanks, Andy KU7T From: softrock40@yahoogroups.com
andreash23y
4
posts
Mar 26

Looking for a 192kHz USB "sound card"

(1)
Aloha! I've had enough fun with the 96kHz. Before buying new, I'm checking here to see if anyone has a surplus 24bit 192kHz sound card that they'd like to turn
katz.ajamas
1
post
Mar 26

Rocky on win7

(2)
Hi Again Bill I have hooked up my Sound Blaster external card to the Laptop USB port and Rocky can see it OK. With a bit of playing with the Blaster control
M0FMT
2
posts
Mar 25

unsubscribe

(41)
On Tue, Mar 24, 2015 at 7:35 PM, Michael Coslo mjcn3li@... ... Nobody has to act on that. It's handled automatically by Yahoo's software. I have done
JOHN KNOTT
41
posts
Mar 24

Configure RX Ensemble II LF version using usbsoftrock

(15)
Hi Alan, 16 x 220KHz = 3520KHz which is ~ the lower limit of the Si570. ... Ah, that explains it. Nothing to worry about in other words. Mike, Glad its working
jannemoren
15
posts
Mar 23

Rocky on Win7

(2)
I could never get Rocky to run at 64k, only 32k with my Delta 44, but it runs ok with a Sound Blaster X-Fi USB sound board at 64k. I use it all day every day
M0FMT
2
posts
Mar 23

How do I measure...?

(7)
Alan... It lives!!!!! Kit A... it now receives like a workhorse. After receiving your note regarding Si570, I had a look. I had lots of solder on those pins
bjmercer53
7
posts
Mar 22

Raspberry 2 with SR and quisk - preliminary results

(13)
Very interesting indeed. The openHPSDR developers are working on a technique they call DFC (Direct Fourier Transform) using WDSP by NR0V to replace DttSP, the
pvrose@btinternet.com
13
posts
Mar 22

Low power and AM modulation

(2)
Nevermind, found it already :) I was piping the audio through a pulseaudio sink with the wrong sample spec set. It was set to s32le when it should have been
Rocketman768
2
posts
Mar 21

5dash site down?

(3)
... It's fine here. -- Cecil - k5nwa http://thepartsplace.k5nwa.com/
Michael Coslo
3
posts
Mar 21

RXTX Leakage and Transmit Spurs

(70)
Hi, I was not in particular speaking of your measurements, but for example if in measuring, someone used a 10KHz tone and the DMM in the example, they would
warrenallgyer
70
posts
Mar 20

T1 phasing on II lite vs T3 phasing on ensemble

(2)
Original Message ----- Subject: [softrock40] T1 phasing on II lite vs T3 phasing on ensemble ... Bob, ... This is just the way the schematic is drawn. In the
katz.ajamas
2
posts
Mar 19
View First Topic Go to View Last Topic
Loading 1 - 15 of total 13,902 topics