7044Re: [snowkiteidaho] Never mind
- Nov 7, 2010Steve is right you need to turn PSI down to ~10psi. Otherwise, you will burn a hole in bladder. No the bladder does not Burst in to flames, but that would be fun. Better off not using compressor as this will spoil the heck out of you, and you'll never want to pump again. My understanding of your email was that the sand was between casing and bladder??? low psi will not blast sand out ends of kite wing tip velcro ends!!!You guys who are still out there playing on the water...My hat is off to you! Maybe next season I'll play a little later in year, having more fun with my little Calvin. Just pulled out my snow kites and knocking the dust off them :-)!!! Maybe sometime soon??? or maybe we will water kite year round. Climate Change???On Nov 7, 2010, at 7:21 AM, Steve Linane wrote:
GregEvery air compressor has a regulator you can turn it down to 30lb to start and go up from there . Don't want to contradict EDDY but I have used my compressor to inflate my kites and didn't burn a hole or other wise start them on fire .. First when the kite is very dry open the Velcro ends and just try shacking it out . No doubt the sand is stuck along the way so some wrinkling and light hitting with your hand mite loosen it . the problem with water or air is getting access to the individual bladders . The sand cant get in when it is inflated so it most likely its getting in when it is in the bag or on the beach when you roll it up . the ends of the struts are like a tub that folds over and Velcro's in place , very hard for sand to get through there ,most likely it gets in around the inflation valve or valves if yours isn't a single pump . I have found sand inside my bladders at times ( only noticed when I had removed them from kite ) and this was a easy fix just inflate the bladder and pore the sand out the inflation valve . Sand will get in from the pump , on the beach and leavening the cap open in the bag .----- Original Message -----From: Greg DanleySent: Saturday, November 06, 2010 10:07 PMSubject: Re: [snowkiteidaho] Never mind
Thanks for the advice. Looks like there may be wind in the morning. Hope to see you out there.
Sent via BlackBerry by AT&TFrom: Gear Daddy LLC <geardaddyllc@...>Sender: firstname.lastname@example.orgDate: Sat, 6 Nov 2010 22:35:22 -0600ReplyTo: email@example.comSubject: Re: [snowkiteidaho] Never mindSorry do not use compressed airEddy Petranek
On Nov 6, 2010, at 10:25 PM, "Greg Danley" <daflyinhawaiian64@...> wrote:
You say do not use compressed air?
Sent via BlackBerry by AT&TFrom: Gear Daddy LLC <geardaddyllc@...>Sender: firstname.lastname@example.orgDate: Sat, 6 Nov 2010 22:17:33 -0600ReplyTo: email@example.comSubject: Re: [snowkiteidaho] Never mindDo or use compressed air....it will instantly burn holes in bladder.Eddy Petranek
On Nov 6, 2010, at 8:23 PM, "Steve Linane" <stevelinane@...> wrote:Greg do you have a air compressor ?----- Original Message -----From: Greg DanleySent: Saturday, November 06, 2010 6:40 PMSubject: [snowkiteidaho] Never mind
Ok for all those who are laughing their a--'s off I figured it out, sand really chafes when its in your shorts and you wear really tight jeans!
Also there are some handy velcro tabs at the ends of the kite (probably where the sand gets in) and a handy zipper in the middle of the main bladder that one can run the water hose in to rinse out the kite. I hope I got most if not all of it out.
Open to better suggestions.
Sent via BlackBerry by AT&T
- << Previous post in topic Next post in topic >>