Please direct me to the proper files (.h , .cpp, etc) so that the the K3NG controller can operate both AZ and El rotators when using the easycomm protocol. .lstephen_bell
sorry if i disturb you, I'm Filippo IZ5TEP from Itay, i'm using your program from 3 years with potentiometer, and it's fantastic....i love it... Now i'm triyngiz5tep66
Hi Goody, all, A friend of mine is asking me and I don't remember. Where can we set the delay for the rotator's break before to move (not after). I meant, whenea1ddo
We support experimenters of all levels and exchange ideas about amateur radio hardware homebrewing and software development, especially involving Arduinos, Raspberry Pis, computers, microcontrollers, QRP, CW, DSP, satellites, and open source code. Most topics relating to any of these are welcome. Politics, religion, bad karma, mode bigotry, and bad attitudes are not tolerated. This includes political and religious messages, outright or implied, in postings, email signatures, email addresses, pictures, icons, or avatars.
The first one or two posts of new members are moderated, so new posters may notice a delay between post submission and message appearance in the forum. This is inconvenient, but unfortunately is necessary to prevent spamming. Be advised that group members come from all around the world and many speak English as a second language. Please take this into consideration when reading messages or replying.
We are Radio Artisans. Come join us.
- Amateur and Ham Radio
- Oct 26, 2012
- This is a public group.
- Attachments are permitted.
- Members cannot hide email address.
- Listed in Yahoo Groups directory.
- Membership does not require approval.
- Messages from new members require approval.
- All members can post messages.